|
Standard
Features Include:
- 6"
thick aluminized steel insulated oven panel construction.
- Aluminized
steel trim components.
- Prefabricated
corner trim sections.
- Top
or rear mounted burner box system - Completely
pre-assembled, prewired and pre-piped.
- Maxon
slot fired modulating burner with filtered
combustion air.
- One
(1) pre-assembled double door set.
- Aluminized
steel ceiling mounted ductwork designed to SMACNA
standards to avoid direct air impingement/disturbance
of parts.
- Exhaust
fan.
- Pre-assembled
and prewired UL listed Control Panel.
- 460v/3phase/60hz
primary power is std.
- Optional 230v/208v/3ph, 220v/single phase
- Honeywell
digital temperature controller and high limit.
- Honeywell
flame safeguard system with UV flame sensor.
- Powered
exhaust and automatic purge timers.
- Installation
hardware package.
- Installation
drawings and instructions.
- Easy
to follow startup checklist.
- EASY-TUNE
Maxon burner for site-specific efficiency.
- Designed
and built to NFPA, FM or IRI and OSHA standards.
Shipping
Configuration:
- Burner
and manifold: completely assembled.
- Electrical
control panel: completely assembled.
- Powered
exhaust fan: completely assembled.
- Insulated
6" panels & trim package: palletized.
- Doors:
fabricated, includes all hardware.
- Ductwork:
fabricated, pre-formed and notched.
- All
fasteners and mounting hardware: included.
- Complete
assembly, startup and operation instructions: included.
Available
for use with natural gas (NG) or propane (LPG), the
gas-fired oven series use Maxon modulating burner systems,
providing maximum energy efficiency and reduced thermal
shock caused by simple on/off burners. Internally
powered air seals minimize heat loss, and coupled with
the energy efficient modulating Maxon burner, assure
a cost-effective system.
The
exclusive air recirculating system is designed to SMACNA
standards and provides maximum air coverage and efficient
thermal distribution while eliminating direct air impingement.
The Industrial Oven series is specifically designed
to assure that parts remain undisturbed at
the start of the cycle, without the high cost
of variable speed drives. |
